Specification of Fermentation Tank
If you are would like to change, add, remove or modify any part of the tanks, we can accommodate that.
Specific fitting sizes, changes and locations will be set during the design process after a deposit is taken.
| 1. | Design pressure 45 psi (3bar). |
| 2. | working pressure 15psi (1bar). |
| 3. | 4 stainless steel legs with leveling footpads. |
| 4. | Interior shell: 304 stainless steel, thickness 3mm. |
| 5. | Exterior shell: 304 stainless steel, thickness 2mm. |
| 6. | Interior and exterior finish bright polish to 0.6~0.8 μm, hygiene surface . |
| 7. | All Interior welds ground to a smooth0.6~0.8 μm sanitary finish. |
| 8. | Flanged and dished head top and bottom. |
| 9. | 20% head space unless a different volume is requested. |
| 10. | Combined drain extensions and beer port are standard. |
| 11. | Top manway or side manway door. |
| 12. | Dual zone in sidewall and bottom dimple cooling jacket with glycol inlet and outlet. |
| 13. | Polyurethane insulation thickness 80mm for cooling jacket on side and bottom. |
